Wireless Smoke Detector-Photoelectronic

The 5808LST Commercial/Residential Photoelectric Smoke and Heat Detector has a built-in wireless transmitter and two concealed thermistors for heat detection. For difficult to wire locations, room aesthetics or even hazardous materials, like asbestos above a drop ceiling, installation of these wireless devices provides the cost effective solution.

The 5808LST smoke/heat detector can be used with 5881 series (L, M, H) for residential and 5881EH receivers for commercial installations. The transmitter can send alarm, tamper, maintenance low temperature alert (see control panel specifications) and battery condition messages to the systems receiver. The maintenance signal will either indicate that the photochamber requires cleaning or that the detector can no longer respond to smoke and may need replacement. Refer to the wireless systems instructions for the maximum number of transmitters that can be supported.

The 5808LST sounds its built-in temporal code 3 sounder when smoke reaches the detector (the LED also flashes rapidly) or when the air temperature reaches 135F (the LED flashes normally, about once every 40 seconds). A message is also sent to the wireless control panel and the smoke detectors ID number is displayed at the console. During normal, maintenance, and low battery conditions, the LED flashes approximately once every 40 seconds.